DMP Electronics XT30 User Manual

38 XT30/XT50 User Guide User Menu
13. After you complete your selections, the keypad displays
USER # ADDED.
14. Press the Back Arrow key once to add another user or twice
to exit the User Menu.
Changing Own User Code
1. Access the User Menu.
2. Press the CMD key until USER CODES? displays. Press any
select key or area.
3. The display changes to USER CODE? CODE NO: ******.
Press any select key or area.
4. The user code is erased and display changes to CODE NO: -
Type your new user code. Press CMD.
5. Display will show USER XXXX CHNGD to conrm the change.
Changing User Codes
User Code Level: Master only.
1. Access the User Menu.
2. Press the CMD key until USER CODES? displays.
3. Press any select key or area.
The keypad displays ADD DEL CHG SEND.
4. Select CHG to change a user code.
5. At the USER NUMBER: — prompt, enter the user number to
change and press CMD.
6. The display changes to CODE NO: * * * *. Enter the new
user code.
If the code you entered is already in use, or is a code used
internally by the system, the keypad displays ALREADY IN
USE. You must enter a different 4-digit user code.
7. The display then shows the current user name. Press any
top row key to clear. See Entering Names in Appendix C to
enter a new name.
8. If you are changing a code other than your own, the keypad
next displays LEVEL?.
9. Press any select key or area. The keypad displays
SCH LTD STD MSTR.
Refer to steps 11 and 12 in the Adding User Codes section on the
previous page for additional options that can be selected for user
codes with non-Master authority levels.
Note: Changing a user code does not change the user number. User
number 2 may have their user code changed from 1234 to 5678 but
they are still user number 2.
Deleting User Codes
User Code Level: Master only.
1. Access the User Menu.
2. Press the CMD key until USER CODES? displays.
3. Press any select key or area.
The keypad displays ADD DEL CHG SEND.
4. Select DEL to delete a user code from the system.
5. At the USER NUMBER: — prompt, enter the user number
you want to delete and press CMD. The display changes to
USER # DELETED.
6. The display then changes back to USER NUMBER: — for you
to delete another user. Press the Back Arrow key twice to
exit the User Menu.

DMP Electronics XT30 Specifications

General

Brand	DMP Electronics
Model	XT30
Category	Control Panel
Language	English