EasyManua.ls Logo

Dodge Ram 2004 - Page 113

Dodge Ram 2004
642 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TEST ACTION APPLICABILITY
2 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the Left Side Impact Sensor 1 connector.
Disconnect the Airbag Control Module connector.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION ON, THEN RECONNECT THE BATTERY.
Measure the voltage of the Left Side Impact Sensor 1 Signal circuit and sensor 1
ground circuit at the Left Side Sensor 1 connector and ground.
Is there any voltage present?
All
Yes Repair the Left Side Impact Sensor 3 circuits shorted to battery.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No Go To 3
3 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN IGNITION
ON, THEN RECONNECT THE BATTERY.
Measure the resistance of the Left Side Impact Sensor 1 Signal circuit between the
Driver Side Impact Sensor 1 connector and ground.
Is the resistance below 100K ohms?
All
Yes Repair the Left Side Impact Sense 1 Signal circuit shorted for a
short to ground.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No Go To 4
4 Measure the resistance between the Driver Side Impact Sensor Signal and Sensor
Ground circuits at the Left Side Impact Sensor 1 connector.
Is the resistance below 100K ohms?
All
Yes Repair the Left Side Impact Sensor 1 circuits shorted together.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No Go To 5
5 Connect the appropriate Load Tool ACM Adaptor to the Airbag Control Module
connector.
Measure the resistance of the Left Side Impact Sensor 1 Ground circuit between the
Left Side Impact Sensor 1 connector and the Load Tool ACM Adaptor.
Is the resistance below 1 ohm?
All
Yes Go To 6
No Repair the Left Side Impact Sensor 1 Ground circuit open or high
resistance.
Perform __AIRBAG VERIFICATION TEST - VER 1.
6 Measure the resistance of the Left Side Impact Sensor 1 Signal circuit between the
Left Side Impact Sensor 1 connector and the Load Tool ACM Adaptor.
Is the resistance below 1 ohm?
All
Yes Go To 7
No Repair the Left Side Impact Sensor 1 Signal circuit open or high
resistance.
Perform __AIRBAG VERIFICATION TEST - VER 1.
99
AIRBAG
NO LEFT SIDE IMPACT SENSOR 1 COMMUNICATION Continued

Table of Contents

Related product manuals