Symptom:
BATTERY 2 VOLTAGE OPEN
POSSIBLE CAUSES
CHECK FUSE #11
OPEN FUSED B+ CIRCUITS
FRONT CONTROL MODULE
TEST ACTION APPLICABILITY
1 NOTE: This DTC must be active to perform this test. If DTC is stored, erase
DTC and check for an intermittent condition.
Turn the ignition off.
Check fuse #11 in the IPM.
Is the fuse open?
All
Yes → Replace the fuse.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 2
2 Turn the ignition off.
Remove the Front Control Module from the IPM.
Using a 12-volt test light connected to ground, probe both Fused B+ circuits (cavs 6
and 7).
Is the test light illuminated for both circuits?
All
Yes → Replace the Front Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Power Distribution Center (PDC) in accordance with
the service information.
Perform BODY VERIFICATION TEST - VER 1.
416
IGNITION, POWER, ACCESSORY
To Next Page
Loading...
