Symptom:
OCCUPANT CLASSIFICATION MODULE CONFIGURATION MIS-
MATCH
When Monitored and Set Condition:
OCCUPANT CLASSIFICATION MODULE CONFIGURATION MISMATCH
When Monitored: At Ignition on the Airbag Control Module monitors the PCI Bus
messages for OCM PCI Bus messages and then compares the messages to the ACM
configuration.
Set Condition: The DTC will be set if the ACM is not configured for PASSENGER ONLY
OCM and the Occupant Classification Module messages are on PCI Bus.
POSSIBLE CAUSES
ACM NOT CONFIGURED FOR OCM
ACM, OCM CONFIGURATION
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST ACTION APPLICABILITY
1 Turn the ignition on.
NOTE: Ensure that the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
Select the appropriate module and DTC type combination:
All
OCM - ACTIVE DTC
Go To 2
OCM - STORED DTC
Go To 5
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Inspect vehicle for a Occupant Classification System and Passenger On - Off
Indicator.
Is this vehicle equipped with a PassengerAirbag On - OFF Indicator on the dash and
the OCS?
All
Yes → Go To 3
No → Go To 4
111
AIRBAG
To Next Page
Loading...
