Symptom:
PCI BUS INTERNAL FAILURE
When Monitored and Set Condition:
PCI BUS INTERNAL FAILURE
When Monitored: Continuous
Set Condition: The Instrument Cluster fails the loopback test on the PCI Bus.
POSSIBLE CAUSES
INSTRUMENT CLUSTER
TEST ACTION APPLICABILITY
1 NOTE: If this is an active DTC, answer yes to the question.
With the DRBIIIt, erase DTCs.
Cycle the ignition and wait approximately 1 minute.
With the DRBIIIt, read DTCs.
Did this DTC reset?
All
Yes → Replace the Instrument Cluster in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
No → Test Complete.
433
INSTRUMENT CLUSTER
To Next Page
Loading...
