Symptom:
INCORRECT ODOMETER VALUE FOUND
When Monitored and Set Condition:
INCORRECT ODOMETER VALUE FOUND
When Monitored: During power up.
Set Condition: If the Instrument Cluster detects the odometer value memory is cor-
rupted, this code will set. When this code is set the VF Odometer displays[--].
POSSIBLE CAUSES
INSTRUMENT CLUSTER
TEST ACTION APPLICABILITY
1 CAUTION: Do not attempt to exchange or (swap( an Instrument Cluster
from one vehicle to another. Module memory/configuration damage may
occur. Refer to the Instrument Cluster Caution in the Service Information.
NOTE: When this code is set the VF Odometer will display dashes (- -).
NOTE: If the PCM has been replaced, program the new module with the
correct VIN.
Ensure that the Instrument Cluster has not been damaged or previously installed in
a different vehicle.
With the DRBIIIt, erase DTCs.
Cycle the ignition.
With the DRBIIIt, read DTCs.
Did this DTC reset?
All
Yes → Replace and configure the Instrument Cluster in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
No → Test Complete.
431
INSTRUMENT CLUSTER
To Next Page
Loading...
