TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the BTSI Solenoid harness connector.
Disconnect the Instrument Cluster C1 harness connector.
Measure the resistance between the BTSI Solenoid Control circuit and the BTSI
Solenoid Ground circuit.
Is the resistance below 5.0 ohms?
All
Yes → Repair the BTSI Solenoid Control circuit for a short to the BTSI
Solenoid Ground circuit.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 4
4 Turn the ignition off.
Disconnect the BTSI Solenoid harness connector.
Disconnect the Instrument Cluster C1 harness connector.
Measure the resistance between ground and the BTSI Solenoid Control circuit.
Is the resistance below 5.0 ohms?
All
Yes → Repair the BTSI Solenoid Control circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 5
5 Turn the ignition off.
Disconnect the BTSI Solenoid harness connector.
Disconnect the Instrument Cluster C1 harness connector.
Measure the resistance of the BTSI Solenoid Control circuit between the Solenoid
connector and the Instrument Cluster C1 connector.
Is the resistance above 5.0 ohms?
All
Yes → Repair the BTSI Solenoid Control circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 6
6 Turn the ignition off.
Disconnect the BTSI Solenoid harness connector.
Turn the ignition on.
Using a 12-volt test light connected to ground, check the BTSI Solenoid Control
circuit.
With the DRBIIIt, actuate the BTSI Solenoid.
Does the test light illuminate brightly?
All
Yes → Replace the BTSI Solenoid in accordance with the Service Infor-
mation.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and configure the Instrument Cluster in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
430
INSTRUMENT CLUSTER
BTSI OUTPUT CIRCUIT SHORTED OR OPEN — Continued
To Next Page
Loading...
