Dodge Ram 2004 - Passenger off Indicator Circuit Short to Battery

Symptom:
PASSENGER OFF INDICATOR CIRCUIT SHORT TO BATTERY
When Monitored and Set Condition:
PASSENGER OFF INDICATOR CIRCUIT SHORT TO BATTERY
When Monitored: When the ignition is on, the ACM monitors the PAB Indicator Driver
circuit for voltage from the PAB Off indicator circuit.
Set Condition: The code will set if the ACM senses battery voltage on the PAB Indicator
Driver circuit.
POSSIBLE CAUSES
CHECKING EQUIPMENT
PAB ON - OFF SWITCH INDICATOR SHORT
PASSENGER AIRBAG INDICATOR SHORT TO FUSED RUN - START CIRCUIT
PASSENGER AIRBAG INDICATOR DRIVER CIRCUIT SHORTED TO BATTERY
ACM, PAB INDICATOR DRIVER CIRCUIT SHORT TO BATTERY
STORED CODE OR INTERMITTENT CONDITION
ACTIVE CODE PRESENT
TEST ACTION APPLICABILITY
1 Turn the ignition on.
NOTE: Ensure that the battery is fully charged.
NOTE: For the purpose of this test, the AECM and ORC modules will be
referred to as an ACM.
SELECT ACTIVE or STORED DTC:
All
ACM - ACTIVE DTC
Go To 2
ACM - STORED DTC
Go To 7
NOTE: When reconnecting Airbag system components, the ignition must be
turned off and the battery must be disconnected.
2 Is this vehicle equipped with a Passenger Airbag On - Off Switch? All
Yes → Go To 3
No → With the DRBIIIt in MISCELLANEOUS, read the Configure for
Airbag ON - OFF Switch current status. Enter the number 1 and
press enter to re configure the ACM for NO AIRBAG ON/OFF
SWITCH.
Perform __AIRBAG VERIFICATION TEST - VER 1.
121
AIRBAG