Symptom:
BATTERY VOLTAGE OPEN
POSSIBLE CAUSES
OPEN B+ CIRCUIT
FRONT CONTROL MODULE
TEST ACTION APPLICABILITY
1 NOTE: This DTC must be active to perform this test. If DTC is stored, erase
DTC and check for an intermittent condition.
Turn the ignition off.
Remove the Front Control Module from the IPM.
Using a 12-volt test light connected to ground, probe the B+ circuit (cav 10).
Is the test light illuminated?
All
Yes → Replace the Front Control Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Power Distribution Center (PDC) in accordance with
the service information.
Perform BODY VERIFICATION TEST - VER 1.
417
IGNITION, POWER, ACCESSORY