Symptom:
MIC-WASH-BEAM INPUT CIRCUIT SHORTED
When Monitored and Set Condition:
MIC-WASH-BEAM INPUT CIRCUIT SHORTED
When Monitored: With the ignition on.
Set Condition: The Instrument Cluster detects less than 0.05 volts on the Wash/Beam
Select Switch Feed circuit.
POSSIBLE CAUSES
INTERMITTENT CONDITION
MULTI- FUNCTION SWITCH
WASH/BEAM SELECT SWITCH FEED CIRCUIT SHORT TO GROUND
INSTRUMENT CLUSTER
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, clear all MIC DTC’s.
Turn the Wipers on.
With the DRBIIIt, read the DTC information.
Does the DRBIIIt read: Wash-Beam Input Circuit Shorted?
All
Yes → Go To 2
No → The condition that caused the symptom is currently not present.
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
2 Turn the ignition off.
Disconnect the Multi- Function Switch harness connector.
Turn the ignition on.
With the DRBIIIt in Sensors, read the Wash - Beam SW Volts.
Does the DRBIIIt display more than 4.5 volts?
All
Yes → Replace the Multi- Function Switch in accordance with the
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 3
544
WINDSHIELD WIPER & WASHER
To Next Page
Loading...
