Symptom:
FCM-WASHER PUMP OUTPUT CIRCUIT OPEN
When Monitored and Set Condition:
FCM-WASHER PUMP OUTPUT CIRCUIT OPEN
When Monitored: With the igntion on.
Set Condition: The FCM detects more than 5.0 volts on the Washer Pump Motor Control
circuit.
POSSIBLE CAUSES
INTERMITTENT CONDITION
WASHER PUMP MOTOR
WASHER PUMP MOTOR GROUND CIRCUIT OPEN
WASHER PUMP MOTOR CONTROL CIRCUIT OPEN
POWER DISTRIBUTION CENTER
FRONT CONTROL MODULE
TEST ACTION APPLICABILITY
1 Turn the ignition on.
With the DRBIIIt, clear all FCM DTC’s.
Actuate the Wiper Washers.
With the DRBIIIt, read the DTC information.
Does the DRBIIIt read: Washer Pump Output Circuit Open?
All
Yes → Go To 2
No → The condition that caused the symptom is currently not present.
Inspect the related wiring for a possible intermittent condition.
Look for any chafed, pierced, pinched, or partially broken wires.
Perform BODY VERIFICATION TEST - VER 1.
2 Turn the ignition off.
Disconnect the Washer Pump Motor harness connector.
Connect a jumper wire between cavity 1 and cavity 2.
Turn the ignition on.
With the DRBIIIt, read DTCs.
Does the DRBIIIt display: Washer Pump Output Circuit Low?
All
Yes → Replace the Washer Pump Motor - Front in accordance with the
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 3
534
WINDSHIELD WIPER & WASHER
To Next Page
Loading...
