TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Washer Pump Motor harness connector.
Measure the resistance between ground and the Washer Pump Motor Ground circuit.
Is the resistance above 5.0 ohms?
All
Yes → Repair the Washer Pump Motor Ground circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 4
4 Turn the ignition off.
Disconnect the Washer Pump Motor harness connector.
Disconnect the IPM C3 harness connector.
Measure the resistance of the Washer Pump Motor Control circuit.
Is the resistance above 5.0 ohms?
All
Yes → Repair the Washer Pump Motor Control circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 5
5 Turn the ignition off.
Disconnect the FCM from the IPM.
Disconnect the IPM C3 harness connector.
Measure the internal resistance of the IPM Washer Pump Motor Control circuit.
Is the resistance above 5.0 ohms?
All
Yes → Replace the Power Distribution Center (PDC) in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Front Control Module (FCM) in accordance with the
Service Information.
Perform BODY VERIFICATION TEST - VER 1.
535
WINDSHIELD WIPER & WASHER
FCM-WASHER PUMP OUTPUT CIRCUIT OPEN — Continued
To Next Page
Loading...
