Symptom:
IGNITION POWER MESSAGE NOT RECEIVED
When Monitored and Set Condition:
IGNITION POWER MESSAGE NOT RECEIVED
When Monitored: With the ignition on.
Set Condition: The Hands Free Module does not receive an Ignition Power Status
message from the MIC.
POSSIBLE CAUSES
ATTEMPT TO COMMUNICATE WITH THE MIC
MODULE
TEST ACTION APPLICABILITY
1 Start and idle the engine.
With the DRBIIIt, attempt to I/D and communicate with the MIC.
Was the DRBIIIt able to I/D or communicate with the MIC?
All
Yes → Go To 2
No → Refer to the Communication category for the related symptom(s).
Perform BODY VERIFICATION TEST - VER 1.
2 With the DRBIIIt, erase DTC’s.
Cycle the ignition switch from off to on and wait approximately 1 minute.
With the DRBIIIt, read DTC’s.
Did this DTC reset?
All
Yes → Replace the Hands Free Module in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
No → Test Complete.
501
TELECOMMUNICATION
To Next Page
Loading...
