TEST ACTION APPLICABILITY
5 Ensure that the battery is fully charged.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the ACM harness connector.
Connect the appropriate Load Tool ACM Adapter to the ACM connector.
Turn the ignition on and then reconnect the Battery.
Using a 12-volt test light connected to ground, probe the Fused Ignition Switch
Output (Run) Circuit and the Fused Ignition Switch Output (Run/Start) Circuit at
the ACM connector.
NOTE: One open circuit will not cause a NO RESPONSE condition.
Is the test light illuminated on both circuits?
All
Yes → Go To 6
No → Repair the Fused Ignition Switch Output (Run) and Fused
Ignition Switch Output Run-Start circuits for an open.
Perform __AIRBAG VERIFICATION TEST - VER 1.
NOTE: When reconnecting airbag system components, the ignition must be
turned off and the battery must be disconnected.
6 Ensure that the battery is fully charged.
WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Disconnect the ACM harness connector.
Connect the appropriate Load Tool ACM Adapter to the ACM connector.
Using a 12-volt test light connected to 12-volts, probe the ground circuit.
NOTE: Make sure test light is connected to the Battery positive terminal.
Is the test light illuminated?
All
Yes → Go To 7
No → Repair the Ground circuit for an open.
Perform __AIRBAG VERIFICATION TEST - VER 1.
When reconnectingAirbag system components, the ignition must be turned
off and the battery must be disconnected.
104
AIRBAG
NO PCI LOOPBACK — Continued
To Next Page
Loading...
