TEST ACTION APPLICABILITY
7 Disconnect the Airbag Control Module connector
NOTE: Check connectors - Clean and repair as necessary.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
Connect the appropriate Load Tool ACM Adaptor to the Airbag Control Module
connector(s).
Measure the resistance of the PAB Indicator Driver circuit between the ACM and the
PAB On - Off Switch connector.
Is the resistance below 5.0 ohms?
All
Yes → Go To 8
No → Repair the open Passenger Airbag Indicator Driver circuit.
Perform __AIRBAG VERIFICATION TEST - VER 1.
8 Measure the resistance of the PAB Indicator Driver circuit between the PAB On - Off
Switch connector and ground.
Is the resistance below 10K ohms?
All
Yes → Repair the Passenger Airbag Indicator Driver circuit short to
ground.
Perform __AIRBAG VERIFICATION TEST - VER 1.
No → Go To 9
9 WARNING: TO AVOID PERSONAL INJURY OR DEATH, TURN THE IGNI-
TION OFF, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BE-
FORE PROCEEDING.
Reconnect the PAB Indicator connector.
WARNING: IF THE AIRBAG CONTROL MODULE IS DROPPED AT ANY
TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRE-
CAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT
AND PERSONAL INJURY OR DEATH.
If there are no possible causes remaining, view repair.
All
Repair
Replace the Airbag Control Module in accordance with Service
Instructions.
Perform __AIRBAG VERIFICATION TEST - VER 1.
126
AIRBAG
PASSENGER OFF INDICATOR CIRCUIT SHORT TO GROUND — Continued
To Next Page
Loading...
