TEST ACTION APPLICABILITY
7 Turn the ignition off.
Disconnect the Clockspring C1 harness connector.
Disconnect the Instrument Cluster harness connectors.
Measure the resistance of the Radio Control MUX circuit between the Instrument
Cluster connector and the Clockspring C1 connector.
Is the resistance below 5.0 ohms?
All
Yes → Go To 8
No → Repair the Radio Control MUX circuit for an open between the
clockspring and the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1.
8 If there are no possible causes remaining, view repair. All
Repair
Replace the Instrument Cluster in accordance with the service
information.
Perform BODY VERIFICATION TEST - VER 1.
231
AUDIO
REMOTE RADIO SWITCH CIRCUIT HIGH — Continued
To Next Page
Loading...
