TEST ACTION APPLICABILITY
4 Turn the ignition off
Disconnect the left side Multifunction Switch connector.
Disconnect the Instrument Cluster C2 connector.
Measure the resistance of the Headlamp Switch Sense circuit.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Instrument Cluster.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Headlamp Switch Sense circuit for an open condition.
Perform BODY VERIFICATION TEST - VER 1.
358
EXTERIOR LIGHTING
MIC-HEADLAMP SWITCH INPUT CIRCUIT OPEN — Continued
To Next Page
Loading...
