TEST ACTION APPLICABILITY
2 CAUTION: The evaporator temperature must be above 12.7°C (55°F) to test
A/C system operation.
Turn the ignition on.
With the DRBIIIt, check the PCM for any DTCs.
Are any DTCs present?
All
Yes → Refer to Powertrain Diagnostic Information. After the repair is
complete, with the DRBIIIt, erase the DTC(s). Cycle the ignition
switch. Start the engine. Set the blower control to high speed.
With the DRBIIIt, actuate the Cooldown Test.
Perform BODY VERIFICATION TEST - VER 1.
No → Refer to the Service Information for additional Cooldown Test
related diagnostic information and testing procedures.
Perform BODY VERIFICATION TEST - VER 1.
383
HEATING & A/C
COOLDOWN TEST SENSOR FAILURE — Continued
To Next Page
Loading...
