MIL INDICATOR OUTPUT CIRCUIT SHORTED
When Monitored: With the ignition on and when requested to turn on by the Powertrain
Control Module.
Set Condition: The Instrument Cluster feedback status on the MIL Lamp shows that a
short circuit condition exists. (Below 0.3 volts when ON).
WAIT TO START INDICATOR OUTPUT CIRCUIT OPEN
When Monitored: With the ignition on and when requested to turn on by the Engine
Control Module.
Set Condition: The Instrument Cluster feedback status on the Wait-to-Start Lamp shows
that an open circuit condition exists. (Above 5.0 volts when ON).
WAIT TO START INDICATOR OUTPUT CIRCUIT SHORTED
When Monitored: With the ignition on and when requested to turn on by the Engine
Control Module.
Set Condition: The Instrument Cluster feedback status on the Wait-to-Start Lamp shows
that a short circuit condition exists. (Below 0.3 volts when ON).
POSSIBLE CAUSES
INSTRUMENT CLUSTER
TEST ACTION APPLICABILITY
1 NOTE: Diagnose and repair any PCM (ECM if diesel equipped), or Commu-
nication DTCs before proceeding with this test.
NOTE: If any indicator being diagnosed operates during the Instrument
Cluster bulb check, refer to the appropriate system category for diagnos-
tics.
The Instrument Cluster indicator LEDs are not replaceable, view repair.
All
Repair
Replace and configure the Instrument Cluster in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
426
INSTRUMENT CLUSTER
ABS INDICATOR OUTPUT CIRCUIT OPEN — Continued
To Next Page
Loading...
