TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the PCM harness connector.
CAUTION: If NGC, DO NOT PROBE THE PCM HARNESS CONNECTORS.
PROBING THE PCM HARNESS CONNECTORS WILL DAMAGE THE PCM
TERMINALS RESULTING IN POOR TERMINAL TO PIN CONNECTION.
INSTALL MILLER SPECIAL TOOL #8815 TO PERFORM DIAGNOSIS.
Disconnect the DRBIIIt from the DLC.
Measure the resistance of the PCI Bus circuit between the PCM connector (from
special tool #8815 if NGC) and the DLC.
Is the resistance below 5.0 ohms?
All
Yes → Replace and program the Powertrain Control Module in accor-
dance with the service information.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the PCI Bus circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
435
INSTRUMENT CLUSTER
PCM MESSAGES NOT RECEIVED — Continued
To Next Page
Loading...
