TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Transmission Range Sensor harness connector.
Disconnect the Instrument Cluster C2 harness connector.
Measure the resistance between ground and the TRS 5 Volt Supply circuit.
Is the resistance below 5.0 ohms?
All
Yes → Repair the TRS 5 Volt Supply circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and configure the Instrument Cluster in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
439
INSTRUMENT CLUSTER
PRNDL SWITCH INPUT CIRCUIT SHORTED (DIESEL ONLY) — Continued
To Next Page
Loading...
