TEST ACTION APPLICABILITY
4 Turn the ignition off.
Disconnect the Seat Belt Switch harness connector.
Measure the resistance between ground and the Seat Belt Switch circuit.
Is the resistance below 5.0 ohms?
All
Yes → Go To 5
No → Repair the Seat Belt Switch Ground circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
5 Turn the ignition off.
Disconnect the Instrument Cluster C1 harness connector.
Disconnect the Seat Belt Switch harness connector.
Measure the resistance of the Seat Belt Switch Sense circuit between the Seat Belt
Switch connector and the Instrument Cluster C1 connector.
Is the resistance above 5.0 ohms?
All
Yes → Repair the Seat Belt Switch Sense circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and configure the Instrument Cluster in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
456
INSTRUMENT CLUSTER
*SEAT BELT WARNING INDICATOR ALWAYS ON - STANDARD CAB —
Continued
To Next Page
Loading...
