TEST ACTION APPLICABILITY
4 Secure a known good transmitter.
Turn the ignition on.
Place transmission in the Park position.
Ensure Vehicle Theft Security System (if equipped) is in Disarm Mode.
With the DRBIIIt, select ELECTRO/MECH CLUSTER, MISCELLANEOUS, PRO-
GRAM New Fob.
Follow the instructions on the DRBIII screen.
Programming mode will last for 30 seconds. To get out of Programming Mode sooner,
press PAGE BACK.
Lock and Unlock the vehicle using the transmitter.
Does the RKE System operate properly?
All
Yes → Replace the original transmitter and program all transmitters
that will be used with this vehicle.
No → Replace the Remote Keyless Entry Module and reprogram all
transmitters used with this vehicle.
Perform BODY VERIFICATION TEST - VER 1.
5 Using the 9001 RF Detector, follow the instructions on the back of the tester and test
the transmitter several times.
Does the signal strength measure 9STRONG9?
All
Yes → Go To 6
No → Replace the transmitter.
6 Turn the ignition on
Place transmission in the Park position.
Ensure Vehicle Theft Security System (if equipped) is in Disarm Mode.
With the DRBIIIt, select ELECTRO/MECH CLUSTER, MISCELLANEOUS, then
PROGRAM New Fob. Follow the instructions on the screen.
Exit PROGRAM RKE.
Activate the Door Locks using the RKE Transmitter.
Did the door locks respond properly to the RKE transmitter commands?
All
Yes → Repair complete.
No → Replace the Remote Keyless Entry Module and reprogram all
transmitters used with this vehicle.
NOTE: When repairs are complete, ensure all transmitters used with the
vehicle have been programmed.
494
POWER DOOR LOCKS/RKE
*RKE INOPERATIVE — Continued
To Next Page
Loading...
