TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Multi- Function Switch harness connector.
Disconnect the Instrument Cluster C2 harness connector.
Measure the resistance of the Intermittent Wiper Switch Sense circuit.
Is the resistance above 5.0 ohms?
All
Yes → Repair the Intermittent Wiper Switch Sense circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and configure the Instrument Cluster in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
547
WINDSHIELD WIPER & WASHER
MIC-WIPER SWITCH INPUT CIRCUIT OPEN — Continued
To Next Page
Loading...
