TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Multi- Function Switch harness connector.
Disconnect the Instrument Cluster C2 harness connector.
Measure the resistance between ground and the Intermittent Wiper Switch Sense
circuit.
Is the resistance below 5.0 ohms?
All
Yes → Repair the Intermittent Wiper Switch Sense circuit for a short to
ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace and configure the Instrument Cluster in accordance with
the Service Information.
Perform BODY VERIFICATION TEST - VER 1.
549
WINDSHIELD WIPER & WASHER
MIC-WIPER SWITCH INPUT CIRCUIT SHORTED — Continued
To Next Page
Loading...
