Domino Ax150i User Manual

OPERATION
4-68 EPT019297 Issue 1 November 2016
139 Print trigger occurred
while printing
The printer received a false trigger signal before the
label finished printing.
Increase the persistence level for the print trigger,
see page 3-38.
The product sensor is faulty.
Replace the product sensor.
Label too long for the product.
Check the printed label and reduce the label length.
213 Inspection Required An inspection is required by an engineer certified
by Domino.
Contact the local support office to organise an
inspection.
234 Gutter Stall The gutter has stalled.
Restart the printer following the correct procedure,
see page 4-16. If the fault reoccurs, switch off the
printer and contact the local support office.
235 Gutter Pump not Rotating The gutter pump has stopped.
Restart the printer following the correct procedure,
see page 4-16. If the fault reoccurs, switch off the
printer and contact the local support office.
236 Gutter Blocked
Attempting to Clear
The printer is attempting to clear an obstruction in
the gutter.
237 Gutter Blocked Dried ink in the gutter.
Clean the print head, see page 5-17 and restart the
printer.
Incorrect shut down procedure followed.
Clean the print head, see page 5-17 and restart the
printer.
Blocked nozzle.
Runt the nozzle unblocking wizard, see page 5-18.
Ink jet incorrectly aligned.
Check the ink jet alignment, see page 5-19.
238 Insufficient gutter vacuum
- Retrying
The printer is attempting to increase the vacuum
within the gutter. Follow any instructions given on
the TouchPanel.
Alert ID Description Possible Cause and Remedy

Domino Ax150i Specifications

General

Print Technology	Continuous Inkjet (CIJ)
Printhead	i-Pulse printhead
User Interface	Touchscreen
Connectivity	Ethernet, USB
Operating Temperature	5°C to 45°C
Ink Type	MEK-free options available
Maximum number of lines	5