EasyManua.ls Logo

Doseuro D Series - Safety Standards During Use

Default Icon
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
XMPE0PCG125NST020 1st edition - 2020
10/76
DANGER!
ATTENTION!
RISK OF SERIOUS INJURIES!
RISK OF SERIOUS INJURIES!
RISK OF SERIOUS INJURIES!
TABLE OF SYMBOLS EN ISO 7010
Disconnect before carrying out maintenance or repairs
To signify that the machine or the equipment, which is not connected to the mains
by a plug, has to be disconnected from all sources of power before carrying out
maintenance or repairs
General warning sign
To signify a general warning
Warning; electricity
To warn of electricity
Warning; Hot surface
To warn of a hot surface
Warning; Corrosive substance
To warn of a corrosive substance
Warning; Risk of crushing hands
To warn of a closing motion of mechanical parts of equipment
ATTENTION!
It means that not following the safety rules can cause slight injury
to persons or damage to property.
DANGER!
It means that not following the safety rules can cause injury to
persons or damage to property.
RISK OF SERIOUS INJURIES!
It means that non-compliance with the safety standards
may cause serious personal injuries or damage to
property.
The operations referred to by these symbols must be carried out by professionally qualified personnel, with specific
skills for areas characterised by the presence of a potentially explosive atmosphere.
Failure to comply with the regulations may cause serious personal injuries or damage to property.
3 - SAFETY STANDARDS DURING USE
The purpose of this section is to illustrate pump use with respect to essential safety standards.
To use the dosing pump, the installer and operator must carefully read this section in order to guarantee
the safety of operators and the surrounding property.
DOSEURO declines any liability in case of personal injury or property damage deriving from the
incorrect or improper use of the pump.
If the pump is to be used for other processes the customer must, to be able to re-use it, request
information from our engineering department on the compatibility of the materials for correct use.
The main risks connected with pump use are:
RESIDUAL RISK!

Table of Contents