❑ Considering its importance, the following warnings must be considered:
✓ Never remove the plate from the original position it was placed in.
✓ Do not modify or counterfeit technical data.
✓ Do not clean the plate using abrasive products in order to avoid ruining the data shown.
✓ Do not paint, abrade or make the plate illegible
The plate must be preserved so that all elements contained in it can be read. Use the identification
data to request spare parts, technical information and assistance.
The loss of this data may void the product's EC conformity as this is where the compulsory CE MARKING
is positioned (with possible disputes in case of inspections by the safety and supervisory authorities).
Should this occur, the user must warn the manufacturer of this loss, identifying the pump from the
technical documentation provided with the machine or from the administrative documents. Request a new
one from the DOSEURO assistance service.
4.7 - Sound vibration
The pump is designed and constructed so as to reduce the sound emission level at the source.
The sound pressure level in the workplace is less than 80 dB (A).
The data expressed in the tables take into account the general requirements of European Directive
2006/42/EC.
Below are the results of the phonometric measurements carried out on the series pumps.
These tests were carried out by an external laboratory in compliance with Directives and Standards UNI
EN ISO 3744:2009 and Directive ISO 2002/44/EC.
Table of the sound level pressure survey
To Next Page
Loading...
