Dräger CMS

Dräger CMS Analyzer 55
Operation
7.8 Switching off the analyzer
 Move sliding switch to position 0. The
inserted chip is automatically ejected
from the chip outlet.
7.9 Removing the chip
1. Move sliding switch to position 0:
The chip is ejected from the chip outlet and
the analyzer switches off.
Do not block the chip or chip outlet!
2. Pull the chip out completely without
damaging it. It should only be held by its
edge and returned to its original
packaging for later use.
Seal the packaging to protect the chip
from light!
3. Chips must be stored so that they are
safe from unauthorized persons. Used
chips and chips that have exceeded their
operating time can be sent back to
Dräger.
04222837.eps
0
1
2
3
0
1
2
3