Technical manual | X-am® 3500/8000 49
Maintenance
To add a physical sensor, follow the same procedure used to exchanging a sensor.
However, instead of the a sensor, there is a sensor placeholder in sensor damper.
When the sensor type is exchanges, the sensor damper must also be exchanged
accordingly.
When a sensor is removed from the gas detector and not replaced, a corresponding
sensor placeholder (IR, CatEx, PID, EC) must be inserted in its place.
Equipment:
– Torx T8 screw driver
– Special tool for removing EC sensors
– New sensor
– Sensor damper, if required
– Sensor placeholder, if required
Exchange the sensors using the Dräger CC-Vision PC program (refer to the Dräger
CC-Vision online help). This tests the sensor compatibility and the respective
gasses.
Procedure:
1. Connect the gas detector to a PC. For further information, see the following
chapter: "Connect the gas detector to a PC.", page 66.
2. Start the sensor exchange wizard in the Dräger CC-Vision PC software and
follow the instructions.
3. Open the gas detector. For further information, see the following chapter:
"Opening the gas detector", page 53.
4. Remove the rear cradle of the housing with the battery.
5. Loosen 3 screws (Torx T8) on the options board.
Designation and description Order no.
Sensor damper set:
1x CatEx sensor damper
1x IR sensor damper
1x PID sensor damper
68 13 767
Sensor placeholder set:
1x CatEx sensor placeholder
1x IR sensor placeholder (also for PID)
1x EC sensor placeholder
83 26 818
35002
T 8
To Next Page
Loading...
Need help?
General
