Technical manual | X-am® 3500/8000 73
Technical data
12 Technical data
12.1 Gas detector
In pump mode: If the gas detector is used permanently in pump mode, the
operating time is reduced by approx. 2 h.
Ambient conditions:
during operation and storage -20 to +50 °C
700 to 1300 hPa
10 to 90 % (briefly up to 95 %) rel. hum.
Degree of protection
IP 67
1)
1) Tested without the pump or calibration adapter.
Alarm volume Typically 100 dB (A) at a distance of
30 cm
Orientation Any
Battery Lithium-ion battery, rechargeable, 4.8 V,
6.0 Ah, 28.8 Wh, 250 g
Dimensions approx. 179 x 77 x 42 mm (H x W x D)
Weight (without pump) Typically 495 g depending on which
sensors are equipped, without transport
harness
Weight (with pump) Typically 550 g, depending on which
sensors are equipped, without transport
harness
Update interval for the display and sig-
nals
1s
Bluetooth
®
range
Bluetooth
®
range with rubber boot
Approx. 10 m (line of sight)
Approx. 5 m (line of sight)
Operating time in normal conditions (diffusion mode)
1)
:
1) The nominal operating time of the gas detector at an ambient temperature of 20 to 25 °C,
1013 mbar, alarms less than 1 % of the time, power-save mode display activated. The actual
operating time varies depending on the ambient temperature and pressure and battery and
alarm conditions.
X-am 3500/8000:
With CatEx and 3 EC sensors typically 24 h
With 3 EC sensors typically 120 h
X-am 8000 only:
With IR and 3 EC sensors typically 22 h
With CatEx, PID and 3 EC sensors typically 17 h
With CatEx, IR and 3 EC sensors typically 14 h
With IR, PID and 3 EC sensors typically 16 h
With PID typically 42 h
To Next Page
Loading...
Need help?
General
