Technical manual | X-am® 3500/8000 67
Device settings
8 Device settings
Only trained and qualified personnel may change the device settings.
8.1 Factory settings
Different settings can be selected to meet customer requirements on order. The
setting can be checked and changed with the X-dock maintenance station or the
Dräger CC-Vision PC software.
Function Setting
Fresh air calibration without password On
Bump test without password Off
Operation signal On
Switch off allowed On
Bluetooth
®
(X-am 8000 only, if installed)
Off
Capture range
1)
1) The set capture range can be read out on the gas detector and activated or deactivated. The
capture range is activated at the factory in measuring mode. The capture range is always
deactivated in calibration mode.
On
LEL factor
2)
ch4 (methane)
H
2 (hydrogen)
2) An LEL factor can be adapted to national regulations using the Dräger CC-Vision PC software.
4.4 Vol% (corresponds to 100 %LEL)
4.0 Vol% (corresponds to 100 %LEL)
STEL STEL feature – inactive; average dura-
tion = 15 minutes
TWA TWA feature – inactive; average dura-
tion = 8 hours
Alarm A1 Acknowledgeable; not latching, pre-
alarm, increasing measured value (for
O
2 sensor, decreasing measured value
as well)
Alarm A2 Not acknowledgeable; latching, main
alarm, increasing measured value (for
O
2 sensor, decreasing measured value
as well)
Symbol for type of danger On
Expired bump test interval Warning
Expired calibration interval Channel warning
Power-save mode display On (180 s)
To Next Page
Loading...
Need help?
General
