12 Technical manual | X-am
®
2800 / X-am
®
5800
Operation
1. Switch on the gas detector. The current measured values are shown in the
display.
2. Observe warnings, error messages and special states.
3. Verify that the gas inlet openings and membranes are clean, freely accessible,
dry and undamaged.
4. Check that the date and time are set correctly.
4.5 Connecting a gas detector to a smartphone
The gas detector can be connected to a suitable smartphone via Bluetooth
®
. The
Bluetooth
®
feature and the GATT (Generic Attribute Profile) interface (subject to
licensing) can be activated via the CC-Vision PC software or
1)
the Quick menu.
Data transmitted via Bluetooth
®
can be used for additional safety measures.
However, the data does not replace primary on-site measures by the gas detector.
The alarm on the gas detector is decisive. An important consideration is that a
mobile network and WLAN reception are not always available or can be interrupted.
For specific features, Dräger offers apps that can be installed on a suitable
smartphone or tablet. A license may be required under certain circumstances. For
detailed information on connecting via Bluetooth
®
also refer to the instructions for
use of the smartphone used.
Prerequisites
– Bluetooth
®
is activated on the gas detector and the smartphone.
WARNING
Risk of explosion
The use of an unsuitable smartphone in an explosion-hazard area may lead to the
ignition of flammable or explosive atmospheres.
► The smartphone must be suitable and approved for use in explosion-hazard
areas.
The Bluetooth
®
feature is not part of the technical suitability test and may only be
used in countries for which approval is available. Contact Dräger if you have any
questions about availability.
Contamination of the gas detector or shielding elements (e.g. case) can reduce
the Bluetooth
®
range.
Failure of the Bluetooth® communication of the gas detector is to be expected in
the vicinity of strong transmitters in the range of the 2.4 GHz band.
When connecting a new smartphone, the connection that is currently stored is
deleted during this process.
1. Switch on the gas detector.
2. Call up the Quick menu: Press 3x in measuring mode.
3. Select Bluetooth
®
connection and confirm.
1) To do this, the feature must be activated in the Quick menu.
To Next Page
Loading...
Need help?
General
