Dräger MQG 02 0 Series - Page 3

Technical manual | X-am
®
2800 / X-am
®
5800 3
Contents
6.2 Calibration intervals ........................................................................ 23
6.3 Test gases ...................................................................................... 23
6.4 Performing the bump test ............................................................... 23
6.5 Perform a bump test with the Bump Test Station ........................... 25
6.6 Check response time (t90).............................................................. 26
6.7 Calibrating the gas detector............................................................ 26
6.7.1 Notes on calibration.......................................................... 26
6.7.2 Performing a fresh air calibration...................................... 27
6.7.3 Carrying out a single-gas calibration ................................ 28
6.7.4 Carrying out a mixed gas calibration ................................ 29
6.8 Charging the battery ....................................................................... 30
6.9 Charge the battery with the multicharger........................................ 31
6.10 Replacing the battery...................................................................... 33
6.11 Exchanging, adding or removing a sensor ..................................... 33
6.12 Cleaning the PID lamp (X-am 5800 only) ....................................... 38
6.13 Exchange the device components.................................................. 39
6.13.1 Opening the gas detector ................................................. 39
6.13.2 RFID transponder (optional) ............................................. 40
6.13.3 Horn resonator.................................................................. 41
6.14 Cleaning.......................................................................................... 42
7 Configuration............................................................................................ 42
7.1 Standard gas configuration for X-am 2800 ..................................... 42
7.2 Standard gas configuration for X-am 5800 ..................................... 43
7.3 Configuring the gas detector........................................................... 44
7.3.1 Configuring the gas detector with the PC and reading the
data memory..................................................................... 44
8 Device settings ......................................................................................... 45
8.1 Factory settings .............................................................................. 45
8.2 Device and sensor settings............................................................. 46
8.3 Alarm settings (factory setting) ....................................................... 48
9 Storage...................................................................................................... 48
10 Disposal .................................................................................................... 49
11 Technical data .......................................................................................... 49
11.1 Gas detector ................................................................................... 49
11.2 Dimensions ..................................................................................... 50
11.3 Dimensions for vehicle mount......................................................... 51