Instructions for use Polaris 600 57
Operation
Setting the light field diameter on the
sterilizable handle E
Double-tapping with one finger on the surface of
the operating section at any location will adjust the
light field diameter.
1 Double-tap with one finger (A).
The light field diameter is increased by one
step.
2 Double-tap again with one finger (A).
The light field diameter is increased by a
further step.
3 The change in the light field diameter is shown
by the LED indicator (B).
If the largest light field diameter has been
reached, double-tapping again will reset the
light field diameter to its smallest size.
– For further information on the light field
diameter, see "Technical light data" on page
92.
NOTE
If several fingers touch the operating section of
the sterilizable handle E simultaneously, the
operating signal will not be implemented. Only
one finger at a time must touch the operating
section.
NOTE
The operating section of the sterilizable handle E
must be dry to guarantee proper operability.
26614
26620
To Next Page
Loading...
Need help?
General
