Dräger Polaris 600 User Manual

Instructions for use Polaris 600 59
Operation
Operating the MedView camera using the wall-mounted control panel
For a Polaris 600 light with MedView camera, the
camera control area is on the right-hand side of the
shared wall-mounted control panel.
Switching the MedView camera on
 Press the key (A).
The status LED (B) lights up.
– After switch-on, the camera runs through an
initialization procedure. This procedure takes
about 15 seconds.
–The Automatic exposure and Autofocus
functions are activated by default.
– The camera can also be operated when the
Polaris 600 light is in standby mode.
Switching the MedView camera off
 Press the key (A).
The camera is in standby mode.
The status LED (B) is not lit.
– The key does not disconnect the camera
from the mains power supply (camera in
standby mode).
28134
A
B
C
D
26358
A
B
C
D

Dräger Polaris 600 Specifications

General

Brand	Dräger
Model	Polaris 600
Category	Medical Equipment
Language	English