Dräger Polaris 600 User Manual

Instructions for use Polaris 600 55
Operation
Color temperature function
The description of this function applies to both the
light control panel and the wall-mounted control
panel. Only the light control panel is shown in the
illustrations.
The light must be switched on before this function
can be activated, see "Switching the light on and
off" on page 48.
There is an indicator with 3 LEDs for the color
temperature. These LEDs indicate the color
temperature set for the light.
– The color temperature when the light is
switched on is the same as the color
temperature set before the light was switched
off.
1 Press the key (A).
The color temperature is increased.
2 Press the key (A) again.
The color temperature is increased by a further
step.
3 The change in color temperature is shown by
the LED indicator (B).
4 If the highest color temperature has been
reached, pressing the key (A) again will
reset the color temperature to its lowest value.
– For further information on color temperature,
see "Technical light data" on page 92.
Polaris 600 (A)
Polaris 200 (B)
Polaris 100 (C)
1650 W/m
2
Acceptable
1) When all lights in the light combination are set to maximum illuminance
2) Maximum permissible total irradiance according to IEC 60601-2-41 corresponds to 1000 W/m
2
Light combina-
tion
Maximum
total irradi-
ance
1)
[W/m
2
]
Recommended adjustment of the total irradi-
ance
2)
by reducing the illuminance
Thermal radiation in
the wound site after
adjustment of the
total irradiance
(C)
(A)
(B)
LED indicator Color temperature
3800 K
4400 K
5000 K
5600 K
26566
A
B

Dräger Polaris 600 Specifications

General

Brand	Dräger
Model	Polaris 600
Category	Medical Equipment
Language	English