Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
4.3 Telnet Access
Once correctly configured, the Horizon Compact is accessible through a Telnet session using Super
User, NOC and Admin level user accounts. Refer to Appendix A for details of CLI commands. The
Horizon Compact system can be completely configured, tested and managed through a Telnet session.
The Telnet function is enabled by default but can be disabled within the Horizon Compact system.
Procedure 4-2
Configuring Telnet Access
Required Action Steps
login Log in as the Super User.
get telnet access
Returns the status of Telnet access (on by default)
Sequence :
get telnet access press Enter
The system responds:
telnet access is [on/off]
set telnet access
Enables or disables Telnet access.
Sequence :
set telnet access [on/off] press Enter
The system responds:
telnet access is [on/off]
save mib
Saves the MIB to RAM. Perform this command to save configuration
changes to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
To Next Page
Loading...