Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
save mib Saves the MIB to RAM. Perform this command save setting changes
to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
This concludes the steps to configure mandatory SSL access to the Horizon Compact for each user
group.
4.7 Event and Performance Logs
The Horizon Compact system supports two logs, the Events Log and the Performance Log. Each can
be used to trace the behaviour of the system over time.
The Events Log is invoked or disabled by issuing the CLI command set logging [on/off]. This log
records alarm and reset events. Approximately 17,500 events can be captured by the Events log. Once
the log is full the oldest entries are overwritten. See
Procedure 4-8 for more details.
Issuing the CLI command set performance logging [on/off] enables or disables the Performance Log.
This log collects system performance information at time intervals that are configured using the CLI
command set performance log interval [hh:mm:ss]. See
Procedure 4-9 and Table 4-2 for more
details.
Procedure 4-8
Events Log
Required Action Steps
login Log in as a NOC account
get logging This command returns the status of the events log
Sequence :
get logging
The system responds :
Logging has been :[enabled/disabled.]
To Next Page
Loading...