Horizon Compact Management
121
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
get log entries This command lists all events entries in the log since the log was
enabled, or after it was last cleared. Ctrl-c aborts the listing.
Sequence :
get log entries
The system responds :
Start of log ...
0 10/07/2005 11:31:36 0 225017 477 W Demodulator lost synchronization
0 10/07/2005 11:31:36 0 225016 476 W Link is down
0 10/07/2005 11:31:36 0 225015 475 I cold start
0 10/07/2005 11:31:36 0 225014 474 W auto negotiation duplex mismatch
0 01/01/1970 00:00:11 0 225013 473 I Initialized Radio Manager
0 01/01/1970 00:00:02 0 225012 472 I Flash Log is initialized
<<<<Press any key to continue.........>>>>
End of log.
set logging This command enables and disables events logging
Sequence :
set logging [on/off]
The system responds :
Logging is :[on/off]
save log Saves the events log to a specified ftp server.
Sequence :
save log ftp:[mylogfile]
Note: The maximum system log file size for ftp to a server holds
about 1200 events (100KB). If more than 1200 events are stored on
the system, then multiple files will be created and named as
"mylogfile1", "mylogfile2" etc.
The system responds (example):
Enter the IP address of FTP server followed by 'Enter' Key :[ip
address]
220 ProFTPD 1.2.5 Server (Dragonwave FTP Site)
[support.dragonwaveinc.com]
UserName :username
331 Password required for username.
Password :*******
230 User username logged in.
Copy log entries to a file? Enter Y(yes) or N (no):y
Trying to copy the data to mylogfile File. Please wait for a while.
200 PORT command successful.
150 Opening ASCII mode data connection for mylogfile.
226 Transfer complete.
Data successfully transferred to specified file. 221 Goodbye.
To Next Page
Loading...