Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
get ssh server fingerprint
Retrieves the fingerprint of the server
Sequence :
get ssh server fingerprint
The system respond :
save mib
Saves the MIB to RAM. Perform this command to save setting
changes to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
Reset system
A system reset is required to activate this feature.
Sequence
reset system press Enter
The system responds:
Are you sure you want to reset? Y(yes) or N(no)
press Y
The system will proceed to reset. You will have to log on again to
regain access.
4.5 Horizon Compact Web Interface
This section provides an overview of the Horizon Compact Web interface. To use the Horizon Compact
Web-based interface, you need a PC with a Web browser (Internet Explorer 5.5 or higher, or Netscape
4.5 or higher) and IP access to the Horizon Compact system. For the PC requirements refer to the
browser vendor documentation.
The Horizon Compact Web interface is disabled by default. Enable the Web interface on both systems by
logging on using Telnet and issuing the CLI command set web server on press Enter.
4.5.1 Features
The following list describes the features of the Horizon Compact Web interface:
• Remote system availability - the Web interface can be used on any computer having
IP access to the Horizon Compact system.
• Runs in a standard Web browser - the Web interface runs on Internet Explorer 5.5 or
higher or Netscape 4.5 or 4.7
• Requires no local software - the Web interface runs in the browser. All necessary
software is stored on the Horizon Compact system.
• Controlled access levels depending upon login type - Super User, NOC and Admin
level functions are supported based upon login type.
To Next Page
Loading...