DragonWave Inc. 58
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
3.7.6 Configure Authentication
Should you require more security than offered by the default authentication mode of No Authentication,
you will need to configure the authentication key to suit your requirements. Follow the steps in the
following procedure.
Procedure 3-10
Setting Unique Authentication
Perform this procedure to set system authentication to unique.
Note: You must perform the authentication procedures in the sequence that they appear in this manual.
Required Action Steps
login Log in as a NOC user on both ends of the system and run the CLI
command get hw inventory as shown below, to retrieve the
authentication keys from each unit.
get hw inventory Displays the serial numbers of the various sections in the system.
Perform this command at each end of the link and record the
authentication keys (Unit Serial Number) for each end.
Sequence:
get hw inventory press Enter
The system responds:
Frequency File PartNumber : number
Unit Serial Number : number
Unit Assembly Number : number
NCC Serial Number : number
NCC Assembly Number : number
IF Serial Number : number
IF Assembly Number : number
Radio Serial Number : number
Radio Assembly Number : number
Diplexer Serial Number : number
Diplexer Assembly Number : number
To Next Page
Loading...