DragonWave Horizon COMPACT - Page 84

DragonWave Inc. 84
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Procedure 3-17
Configuring Automatic Adaptive Modulation
Required Action Steps
login Log in as a NOC user.
get aam status Displays the current status of the Automatic Adaptive Modulation
setting. Note that AAM cannot be invoked if RLS is enabled.
Sequence :
get aam status press Enter
The system responds :
Aam set to:on/off
set aam This command turns the Automatic Adaptive Modulation (AAM) option
on or off. Note that AAM cannot be invoked if RLS is enabled.
Sequence :
set aam <on/off> press Enter
The system responds :
Aam set to:on
Save mib and restart system.
OR
Aam set to:off
save mib
Saves the MIB to RAM. Perform this command to save setting
changes to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
Reset system
A system reset is required to activate this feature.
Sequence
reset system press Enter
The system responds:
Are you sure you want to reset? Y(yes) or N(no)
press Y
The system will proceed to reset. You will have to log on again to
regain access.