Vigor2920 Series User’s Guide
265
Status
Display if such rule is enabled (Active) or not.
Local Address
Display the local IP address (on LAN) for the rule.
Remote Address
Display the remote IP address (on LAN/WAN) for the rule.
DiffServ CodePoint
Display the levels of the data for processing with QoS
control.
Service Type
Display the service type of the data for processing with QoS
control
3. For adding a new rule, click Add to open the following page.
Available settings are explained as follows:
Item Description
ACT
Check this box to invoke these settings.
Ethernet Type
Please specify which protocol (IPv4 or IPv6) will be used for
this rule.
Local Address
Click the Edit button to set the local IP address (on LAN) for
the rule.
Remote Address
Click the Edit button to set the remote IP address (on
LAN/WAN) for the rule.
Edit
It allows you to edit source address information.
Address Type – Determine the address type for the source
address.
For Single Address, you have to fill in Start IP address.
For Range Address, you have to fill in Start IP address and
To Next Page
Loading...
Need help?
General
