Vigor3900 Series User’s Guide
214
If you choose IPSec as the Type in Step 1, you will get the following page:
Available parameters are listed as follows:
Item Description
Profile
Display the name of the profile.
Enable This Profile
Check this box to enable such profile.
Auth Type
The authentication to be used by Pre-Shared Key or RSA
Signature. Choose PSK or RSA for such profile.
Certificate
Choose a local certificate from the drop down list.
Preshared Key
Type a pre-shared key for authentication if PSK is selected
as Auth Type.
Security Protocol
Choose ESP to specify the IPSec protocol for the
Encapsulating Security Payload protocol. The data will be
encrypted and authenticated. Choose AH to specify the
IPSec protocol for the Authentication Header protocol. The
data will be authenticated but not be encrypted.
WAN Profile
Choose a WAN profile to be used by such profile.
Local IP / Subnet
Mask
Type the IP address and subnet mask of local host.
Local Next Hop
Specify the gateway for WAN interface. Usually, use the
default setting (leave it in blank).
Remote Host
Type the WAN IP address for the remote host.
Remote IP / Subnet
Mask
Type the LAN IP address and LAN subnet mask for the
remote host.
Local GRE IP
The virtual IP address of the router, specified for this tunnel.