Vigor3900 Series User’s Guide
221
Available parameters are listed as follows:
Item Description
Profile
Type the name of the profile.
Enable This Profile
Check this box to enable this profile.
Type
There are three types offered here for you to choose. Please
choose IPSec for this case.
Basic
Always On – Click Enable to make router always keeping
connection.
For Remote Dial-In - Click Enable to allow the connection
via IPSec remote dial-in host.
Auth Type - The authentication to be used by Pre-Shared
Key or RSA Signature. Choose PSK or RSA for such
profile.
Preshared Key - Type a pre-shared key for authentication if
PSK is selected as Auth Type.
Security Protocol – Choose ESP to specify the IPSec
protocol for the Encapsulating Security Payload protocol.
The data will be encrypted and authenticated. Choose AH to
specify the IPSec protocol for the Authentication Header
protocol. The data will be authenticated but not be
encrypted.
WAN Profile- Choose a wan profile to be used by such
profile.
Local IP/Subnet Mask - Type the IP address and subnet
mask of local host.
Local Next Hop - Specify the gateway for WAN interface.
To Next Page
Loading...
Need help?
General
