74
Port Range Set the filter Port range.
Src Addr Set source address. It can be single IP address, network address,
complete address 0.0.0.0, or network address similar to *.*.*.0
Des Addr Set the destination address. It can be IP address, network address,
complete address 0.0.0.0, or network address similar to *.*.*.*
Src Mask Set the source address’ mask. For example, 255.255.255.255 means just
point to one host; 255.255.255.0 means point to a network which
network ID is C type.
Des Mask Set the destination address’ mask. For example, 255.255.255.255 means
just point to one host; 255.255.255.0 means point to a network which
network ID is C type.
Apply Save the settings.
Delete Delete the selected rule.
Click the Add button if you want to add a new output rule.
Then enable out access, and click the Apply button.
So when devices execute to ping 192.168.1.118, system will deny the request to send ICMP request to
192.168.1.118 for the out access rule. But if devices ping other devices which network ID is 192.168.1.0,
it will be normal.
To Next Page
Loading...
