59
VAPOR-LOGIC
®
VERSION 6 INSTALLATION AND OPERATION MANUAL
Options and features
SETTING DATE AND TIME
The Vapor-logic controller contains a real-time clock that is used for several
features including the drain and flush sequence and alarm logging. If you need
to reset the date or time, go to the Settings menu.
Note: Verify the date and time settings after every firmware upgrade.
BATTERY BACKUP, NONVOLATILE MEMORY
If there is a power outage, date and time settings will be saved. Alerts, unit
configuration, and usage timers will remain in nonvolatile memory indefinitely.
When the battery is getting low a "Check Battery" alert will appear in the Alert
Log on the touchscreen and in the Message Log of the Web interface.
SECURITY/PASSWORD
To control who can change Vapor-logic settings, enable the security function
and define a password in the Settings menu. Enter four digits, numbers only,
and define the time-out period (minutes of inactivity before Vapor-logic reverts
to read-only mode). The Web interface and the touchscreen can have separate
passwords.
Important: Write down the password and keep in a secure location.
PASSCODE FOR TOUCHSCREEN DISPLAY
On the touchscreen display choose a passcode immediately following the
choice of Require Passcode: Yes. If security is required and the passcode was
not set, try the Vapor-logic default of 0000. If a passcode has been set and
then forgotten, contact DriSteem Technical Support.
OPERATION
To Next Page
Loading...
