61
VAPOR-LOGIC
®
VERSION 6 INSTALLATION AND OPERATION MANUAL
To create a backup file:
1. Insert a USB flash drive into the USB port on the Vapor-logic board.
2. Go to Settings/USB backup-restore/Back up settings
3. Select Yes. The display will prompt you when backup is complete.
To restore from a backup file:
1. Insert a USB flash drive with that humidifier’s backup file into the USB port
on the Vapor-logic board.
2. Go to Settings/USB backup-restore/Restore settings.
3. Select Yes. Note that the serial number of the humidifier and backup file
must match to complete the restore process.
DOWNLOADING FIRMWARE UPDATES
The Vapor-logic controller and the touchscreen display firmware can be field
upgraded to the latest firmware version via the USB port on each device.
Firmware updates are available at no charge on the DriSteem website. One
download from the DriSteem web site will give you all files needed to update
both Vapor-logic and the touchscreen display.
To update your Vapor-logic controller and/or touchscreen display to the latest
firmware version, perform the following procedure:
1. Navigate to www.dristeem.com.
2. Go to Support & Literature on the site navigation menu.
3. Select Technical Support.
4. Click on firmware updates.
5. Navigate to Vapor-logic6 and click version download link.
6. Plug a reliable USB flash drive into a USB port on your computer, and
prepare the flash drive as follows:
a) Move or delete all files from the drive.
b) Make sure it has at least 16 MB of free space.
c) Make sure it is not partitioned into multiple drives.
7. Perform the procedure in Table 62-1.
8. Repeat the procedure in Table 62-1 to get the Vapor-logic6 touchscreen
display update files. They can be placed on the same USB stick.
Firmware updates
OPERATION
To Next Page
Loading...
