= Location of the controller is entered manually. Where multiple controllers
are connected to the DSE890, it may be more appropriate to enter the location
of each device manually. This allows each controller to show on the map at its
specific location instead of showing all controllers at the same location as the
DSE890
= GPS location is transmitted to the DSEWebNet
®
Server. This is used for
live tracking and the Geofence feature of the DSEWebnet
®
system.
Manually entered location of the selected controller.
This is useful in cases where the controller is located some distance from the
Gateway.
For example the generator house may be at one side of a site, with the
Gateway located in the IT department. Manually entering the location of the
generator house shows this location on the DSEWebNet map, rather than the
location of the IT department.
Manually entered location (in degrees) of the DSE890
Locations East of the Greenwich Meridian = positive
Locations West of the Greenwich Meridian = negative
Locations North of the Equator = positive
Locations South of the Equator = negative
For example
54.18º N, 0.31º W is entered as
Latitude: 54.18
Longitude: -0.31
To Next Page
Loading...
